Installation Procedure
- Install the EBCM, if removed. Refer to Electronic Brake Control Module Replacement .
- Install the BPMV assembly (1) to the bracket.
- Install the BPMV bolt (1) and tighten to 10 N.m (89 lb in).
- Connect the left rear brake pipe fitting (1) to the BPMV and tighten to 21 N.m (16 lb ft).
- Connect the right rear brake pipe fitting (2) to the BPMV and tighten to 21 N.m (16 lb ft).
- Connect the master cylinder primary brake pipe fitting (1) to the BPMV and tighten to 21 N.m (16 lb ft).
- Connect the master cylinder secondary brake pipe fitting (2) to the BPMV and tighten to 21 N.m (16 lb ft).
- Connect the left front brake pipe fitting (1) to the BPMV and tighten to 21 N.m (16 lb ft).
- Connect the right front brake pipe fitting (2) to the BPMV and tighten to 21 N.m (16 lb ft).
- Connect the EBCM electrical connector.
- Install the accessory wiring junction block. Refer to Accessory Wiring Junction Block Replacement .
- Bleed the hydraulic brake system. Refer to Hydraulic Brake System Bleeding (Manual) , Hydraulic Brake System Bleeding (Pressure) .
- Turn the ignition switch to the ON position.
- Perform the Diagnostic System Check - Vehicle .
- Observe the brake pedal feel after performing the diagnostic system check. If the pedal now feels spongy, air may have been inor may have been introduced into the primary circuit.
- If the pedal feels spongy, perform the Antilock Brake System Automated Bleed .
CAUTION:
Refer to Fastener Caution .