Communication Interface Module Replacement

WARNING: This page is about a different car, the 2010 GMC Terrain and 2010 Chevrolet Equinox. However, it is still accessible from the selected car via links, so may be relevant.

Fig 1: Communication Interface Module

Courtesy of GENERAL MOTORS CORP.

Callout	Component Name
Preliminary Procedure: Remove the driver side knee bolster reinforcement. Refer to Driver Knee Bolster Reinforcement Replacement (Equinox) or Driver Knee Bolster Reinforcement Replacement (Terrain)
1	Communication Interface Module Bolt (Qty: 2) CAUTION: Refer to Fastener Caution . Tighten: 10 N.m (89 lb in)
2	Communication Interface Module Procedure Disconnect the electrical connections. If replacing the communication interface module be sure to transfer bluetooth antenna, if equipped. For programming and set up procedures, refer to Control Module References

Callout

Component Name

Preliminary Procedure:
Remove the driver side knee bolster reinforcement. Refer to Driver Knee Bolster Reinforcement Replacement (Equinox) or Driver Knee Bolster Reinforcement Replacement (Terrain)

Communication Interface Module Bolt (Qty: 2)

CAUTION: Refer to Fastener Caution .

Tighten: 10 N.m (89 lb in)

Communication Interface Module

Procedure

Disconnect the electrical connections.
If replacing the communication interface module be sure to transfer bluetooth antenna, if equipped.
For programming and set up procedures, refer to Control Module References