Removal Procedure

WARNING: This page is about a different car, the 2010 GMC Terrain and 2010 Chevrolet Equinox. However, it is still accessible from the selected car via links, so may be relevant.

WARNING: Refer to Brake Fluid Irritant Warning .

CAUTION: Refer to Brake Fluid Effects on Paint and Electrical Components Caution .

CAUTION: Always connect or disconnect the wiring harness connector from the EBCM/EBTCM with the ignition switch in the OFF position. Failure to observe this precaution could result in damage to the EBCM/EBTCM.

Place the ignition switch in the OFF position.
Remove the accessory wiring junction block. Refer to Accessory Wiring Junction Block Replacement .
Clean the electronic brake control module (EBCM) to brake pressure modulator valve (BPMV) area of any dirt or debris.
Disconnect the EBCM electrical connector by lifting the locking lever upward.

Fig 1: EBCM Bolts

Courtesy of GENERAL MOTORS CORP.

Remove the 4 EBCM bolts (1).

Fig 2: EBCM

Courtesy of GENERAL MOTORS CORP.

NOTE: Do not pry the components apart.

Carefully pull the EBCM (1) from the BPMV.
Remove the 12 EBCM seals, if necessary.