LEMON Manuals: Even more car manuals for everyone: 1960-2025
Home >> GMC >> 2014 >> Terrain SLT, 4D Utility >> Repair and Diagnosis >> External Pages >> Different car >> Section 49 (Antilock Brake System With Traction Control System & Stability Control System) >> Repair Instructions >> Brake Pressure Modulator Valve Replacement >> Installation Procedure
April 5, 2026: LEMON Manuals is launched! Read the announcement.

Installation Procedure

WARNING: This page is about a different car, the 2010 GMC Terrain and 2010 Chevrolet Equinox. However, it is still accessible from the selected car via links, so may be relevant.
  1. Install the EBCM, if removed. Refer to Electronic Brake Control Module Replacement .
    2. Fig 1: BPMV Assembly
    GM1873931Courtesy of GENERAL MOTORS CORP.
  2. Install the BPMV assembly (1) to the bracket.
    3. Fig 2: BPMV Bolt
    GM1873930Courtesy of GENERAL MOTORS CORP.
    CAUTION: Refer to Fastener Caution .
  3. Install the BPMV bolt (1) and tighten to 10 N.m (89 lb in).
    4. Fig 3: Brake Pipe Fittings
    GM1873926Courtesy of GENERAL MOTORS CORP.
  4. Connect the left rear brake pipe fitting (1) to the BPMV and tighten to 21 N.m (16 lb ft).
  5. Connect the right rear brake pipe fitting (2) to the BPMV and tighten to 21 N.m (16 lb ft).
    6. Fig 4: Master Cylinder Primary Brake Pipe Fitting
    GM1873925Courtesy of GENERAL MOTORS CORP.
  6. Connect the master cylinder primary brake pipe fitting (1) to the BPMV and tighten to 21 N.m (16 lb ft).
  7. Connect the master cylinder secondary brake pipe fitting (2) to the BPMV and tighten to 21 N.m (16 lb ft).
    8. Fig 5: Brake Pipe Fittings
    GM1873924Courtesy of GENERAL MOTORS CORP.
  8. Connect the left front brake pipe fitting (1) to the BPMV and tighten to 21 N.m (16 lb ft).
  9. Connect the right front brake pipe fitting (2) to the BPMV and tighten to 21 N.m (16 lb ft).
  10. Connect the EBCM electrical connector.
  11. Install the accessory wiring junction block. Refer to Accessory Wiring Junction Block Replacement .
  12. Bleed the hydraulic brake system. Refer to Hydraulic Brake System Bleeding (Manual) or Hydraulic Brake System Bleeding (Pressure) .
  13. Turn the ignition switch to the ON position.
  14. Perform the Diagnostic System Check - Vehicle .
  15. Observe the brake pedal feel after performing the diagnostic system check. If the pedal now feels spongy, air may have been in, or may have been introduced into the primary circuit.
  16. If the pedal feels spongy, perform the Antilock Brake System Automated Bleed .
scientia non olet · About LEMON Manuals