LEMON Manuals: Even more car manuals for everyone: 1960-2025
Home >> GMC >> 2016 >> Canyon SL >> Repair and Diagnosis >> External Pages >> Different car >> Section 11 (Programming And Setup - All Systems) >> Repair Instructions >> Power Steering Control Module Programming and Setup >> Reprogram Control Module
April 5, 2026: LEMON Manuals is launched! Read the announcement.

Reprogram Control Module

WARNING: This page is about a different car, the 2017 GMC Canyon and 2017 Chevrolet Colorado. However, it is still accessible from the selected car via links, so may be relevant.

To program an existing power steering control module, or if a new steering gear has been installed, perform the following procedure:

NOTE:

Power Steering Control Module - Setup should not be performed during this procedure.

  1. Install EL-49642  SPS programming support tool.
  2. Ignition ON.
  3. Access the Service Programming System (SPS) and follow the on-screen instructions.
  4. On the SPS Supported Controllers screen, select Power Steering Control Module - Programming and follow the on-screen instructions.
  5. At the end of programming, choose the "Clear All DTCs" function on the SPS screen.
  6. With a scan tool, Clear All DTCs.
    7. NOTE:

    When a new power steering gear is installed, the Steering Angle Sensor Centering procedure is performed during the Wheel Alignment procedure.

  7. Perform Steering Wheel Angle Sensor Centering
scientia non olet · About LEMON Manuals