Removal Procedure

WARNING: This page is about a different car, the 2017 GMC Canyon and 2017 Chevrolet Colorado. However, it is still accessible from the selected car via links, so may be relevant.

CAUTION:

Always connect or disconnect the wiring harness connector from the EBCM/EBTCM with the ignition switch in the OFF position. Failure to observe this precaution could result in damage to the EBCM/EBTCM.

Place the ignition switch in the OFF position.
Raise and support the vehicle. Lifting and Jacking the Vehicle
Remove the transfer case skid shield, if equipped. Transfer Case Skid Shield Replacement
Clean the area surrounding the electronic brake control module (EBCM) and brake pressure modulator valve (BPMV) assembly of any accumulated dirt and debris.
Disconnect the EBCM electrical connector.

Fig 1: EBCM Bolts

Courtesy of GENERAL MOTORS COMPANY

Remove the EBCM bolts (1).

Fig 2: EBCM

Courtesy of GENERAL MOTORS COMPANY

NOTE:

Do not attempt to pry or lever against the EBCM.

Carefully separate the EBCM (1) from the brake pressure modulator valve (BPMV) by pulling straight away from the BPMV.