Installation Procedure
WARNING: This page is about a different car, the 2016 Cadillac ATS. However, it is still accessible from the selected car via links, so may be relevant.
- Multifunction Energy Storage Capacitor Control Module - Install
- Multifunction Energy Storage Capacitor Control Module Nut - Install and tighten Install and tighten 9 N.m (80 lb in)
- Auxiliary Generator Battery Jumper Cable - Install <p01>
- Auxiliary Generator Battery Jumper Cable Nut - Install and tighten 12 N.m (106 lb in)
- Connect the electrical connectors.
- Multifunction Energy Storage Capacitor Control Module Bracket - Install
- Multifunction Energy Storage Capacitor Control Module Bracket Bolt
- Install and tighten to 9 N.m (80 lb in.)
- { If equipped }Active Safety Control Module Bracket - Install
- { If equipped } Active Safety Control Module Bracket Bolt - Install and tighten 2.5 N.m (22 lb in)
- Rear Compartment Side Trim Replacement - Left Side (Sedan with AM9)Rear Compartment Side Trim Replacement - Left Side (Sedan except AM9)Rear Compartment Side Trim Replacement - Left Side (Coupe) -Install
- Connect the negative battery cable. Battery Negative Cable Disconnection and Connection .
- Perform Stop/Start Capacitor Control State Health Reset. Stop/Start Capacitor Control State of Health Reset
CAUTION:
Refer to Fastener Caution .