Installation Procedure
- Clean the sensor housing mating surface of the fascia with a lint-free rag using a naptha solvent or equivalent.
- Mating surface must be dry before applying adhesion promoter.
- Apply adhesion promoter 3M Products P/N 06396 or equivalent to the sensor housing mating surface (1) of the fascia.
- Remove the protective paper backing from the sensor housing.
- Position the sensor housing (1) to the fascia.
- Press firmly to secure the sensor housing to the fascia.
- Install the rear object sensor. Refer to Rear Parking Assist Alarm Sensor Replacement .
- Install the rear fascia. Refer to Rear Bumper Fascia Replacement (Equinox)Rear Bumper Fascia Replacement (Terrain) .
IMPORTANT:
The adhesive and mating surfaces temperature must be between 19 - 43°C (66 - 110°F).
IMPORTANT:
Adhesion promoter MUST be used prior to installing the new sensor housing.