Reprogram Control Module

WARNING: This page is about a different car, the 2016 Cadillac ATS. However, it is still accessible from the selected car via links, so may be relevant.

To reprogram an existing control module, perform the following procedure:

Install EL-49642 SPS Programming Support Tool.
Access the Service Programming System (SPS) and follow the on-screen instructions.
On the SPS Supported Controllers screen, select RDCM Rear Differential Clutch Control Module - Programming and follow the on-screen instructions.
At the end of programming, choose the "Clear All DTCs" function on the SPS screen.
If DTC C0418 is set, then perform the Rear Differential Clutch Classification Calibration procedure. Refer to Rear Differential Clutch Control Module Calibration