Installation Procedure
- WARNING:
Refer to Fuel Pipe Fitting Warning .
Apply a few drops of clean engine oil to the male pipe end.
Push both sides of the quick-connect fitting together in order to cause the retaining feature to snap into place.
Pull on both sides of the quick-connect fitting to make sure the connection is secure.
Insert the tube in the connector until the retainer snaps in place.
- Push down on the redundant latch (1) until it is fully engaged and snapped into position.
Insert the tube in the connector until the retainer snaps in place.
- Push down on the second latch (1) in order to secure the connection.
- Inspect for leaks using the following procedure:
- Turn the ignition ON, with the engine OFF for 2 seconds.
- Turn the ignition OFF, for 10 seconds.
- Turn the ignition ON, with the engine OFF for 2 seconds.
- Turn the ignition OFF.
- Inspect for leaks.