Circuit/System Testing

Ignition OFF, all vehicle systems OFF, disconnect the harness connector at the S47D Seat Memory Switch - Driver. It may take up to 2 min for all vehicle system to power down.
Test for less than 10 Ω between the ground circuit terminal 1 and ground.
- If 10 Ω or greater
1. Ignition OFF.
2. Test for less than 2 Ω in the ground circuit end to end
  - If 2 Ω or greater, repair the open/high resistance in the circuit.
  - If less than 2 Ω, repair the open/high resistance in the ground connection.
- Go to next step: If less than 10 Ω
Ignition ON, press a power seat switch in order to wake up the K40D Seat Memory Control Module - Driver.
Test for 9 V or greater between each signal circuit terminal listed below and ground:
- Memory set switch signal terminal 5
- Memory switch signal terminal 6
- If less than 9 V
1. Ignition OFF, disconnect the X6 harness connector at the K40D Seat Memory Control Module - Driver.
2. Test for infinite resistance between the signal circuit and ground.
  - If less than infinite resistance, repair the short to ground on the circuit.
  - If infinite resistance
3. Test for less than 2 Ω in the signal circuit end to end.
  - If 2 Ω or greater, repair the open/high resistance in the circuit.
  - If less than 2 Ω, replace the K40D Seat Memory Control Module - Driver.
- Go to next step: If 9 V or greater
Ignition OFF, disconnect the X6 harness connector at the K40D Seat Memory Control Module - Driver, ignition ON.
Test for less than 1 V between each signal circuit terminal listed below and ground:
- Memory set switch signal terminal 5
- Memory switch signal terminal 6
- If 1 V or greater
  Repair the short to voltage on the circuit.
- Go to next step: If less than 1 V
Test or replace the S47D Seat Memory Switch - Driver.