Removal Procedure

WARNING:

CAUTION:

Refer to Brake Fluid Effects on Paint and Electrical Components Caution .

CAUTION:

Always connect or disconnect the wiring harness connector from the EBCM/EBTCM with the ignition switch in the OFF position. Failure to observe this precaution could result in damage to the EBCM/EBTCM.

Place the ignition switch in the OFF position.
Radiator Surge Tank (1) - Remove - Radiator Surge Tank Replacement (LYX without KL9) or Radiator Surge Tank Replacement (LTG LYX with KL9) or Radiator Surge Tank Replacement (LH7 FWD) or Radiator Surge Tank Replacement (LH7 AWD)

Courtesy of GENERAL MOTORS COMPANY
Clean the area surrounding the EBCM/BPMV of any accumulated dirt and debris.
NOTE:
The area around the electronic brake control module (EBCM) and brake pressure modulator valve (BPMV) assembly must be free from loose dirt to prevent contamination of disassembled ABS components.
Electronic Brake Control Module Electrical Connector (1) - Disconnect

Courtesy of GENERAL MOTORS COMPANY
Brake Pressure Modulator Valve Secondary Pipe Fitting (1) - Disconnect

Courtesy of GENERAL MOTORS COMPANY
Cap the brake pipe fitting and plug the BPMV inlet port to prevent brake fluid loss and contamination.
Brake Pressure Modulator Valve Primary Pipe Fitting (1) - Disconnect

Courtesy of GENERAL MOTORS COMPANY
Cap the brake pipe fitting and plug the BPMV inlet port to prevent brake fluid loss and contamination.
Right Rear Brake Pipe Fitting (1) - Disconnect

Courtesy of GENERAL MOTORS COMPANY
Cap the brake pipe fitting and plug the BPMV outlet port to prevent brake fluid loss and contamination.
Left Front Brake Pipe Fitting (1) - Disconnect

Courtesy of GENERAL MOTORS COMPANY
Cap the brake pipe fitting and plug the BPMV outlet port to prevent brake fluid loss and contamination.
Right Front Brake Pipe Fitting (1) - Disconnect

Courtesy of GENERAL MOTORS COMPANY
Cap the brake pipe fitting and plug the BPMV outlet port to prevent brake fluid loss and contamination.
Left Rear Brake Pipe Fitting (1) - Disconnect

Courtesy of GENERAL MOTORS COMPANY
Cap the brake pipe fitting and plug the BPMV outlet port to prevent brake fluid loss and contamination.
Brake Pressure Modulator Valve Bracket Bolt (1) - Remove

Courtesy of GENERAL MOTORS COMPANY
Brake Pressure Modulator Valve Bracket Nut (1) - Remove

Courtesy of GENERAL MOTORS COMPANY
Electronic Brake Control Module with Brake Pressure Modulator Valve (1) - Remove

Courtesy of GENERAL MOTORS COMPANY
Brake Pressure Modulator Valve Bolt (1) - Remove

Courtesy of GENERAL MOTORS COMPANY
Brake Pressure Modulator Valve Bracket (1) - Remove

Courtesy of GENERAL MOTORS COMPANY