Installation Procedure
WARNING: This page is about a different car, the 2020 GMC Acadia. However, it is still accessible from the selected car via links, so may be relevant.
Battery Monitor Module (3) - Install
- Battery Post Negative Cable Clamp Nut (1) - Tighten 4.5 N.m (40 lb in)
- Electrical Connector (2) - Connect
Battery Negative Cable (3) - Install
- Use an open ended wrench to hold the battery sensor ground tab, while tightening the battery negative cable nut. (2)
- Battery Negative Cable Nut (1) @Battery Monitor Module - Tighten 11 N.m (97 lb in)
- Perform the battery sensor learn procedure. Battery Sensor Module Learn
CAUTION:
Refer to Fastener Caution