Fastener Specifications
WARNING: This page is about a different car, the 2021 Buick Enclave. However, it is still accessible from the selected car via links, so may be relevant.
Reusable Threaded Fastener Tightening Specifications
|
NOTE:
All fasteners listed in this table can be reused after removal. |
|
|---|---|
| Application | Specification |
| Metric (English) | |
| Intermediate Steering Shaft Lower Bolt | 55 N.m (41 lb-ft) |
| Intermediate Steering Shaft Upper Bolt | 42 N.m (31 lb-ft) |
| Steering Column Lock Control Module Bolt-Rear | 9.5 N.m (7 lb-ft) |
| Steering Column Lock Control Module Bolt-Side | 9.5 N.m (7 lb-ft) |
| Steering Column Tilt Wheel and Telescope Control Module Bolt | 3 N.m (2 lb-ft) |
| Steering Column Nut Refer to procedure for tightening sequence and torque values. |
Steering Column Replacement (N38) , or Steering Column Replacement (N37) |
| Steering Wheel Bolt | 45 N.m (33 lb-ft) |
| Steering Wheel Shroud Bolt | 2.5 N.m (22 lb/in) |
| Turn Signal Switch Bracket Bolt | 9 N.m (80 lb/in) |