Removal Procedure

Courtesy of GENERAL MOTORS COMPANY

Instrument Panel Lower Trim Panel Outer Filler (1) - Remove
Courtesy of GENERAL MOTORS COMPANY

Instrument Panel Lower Insulator Retainer (1) - Remove [ 2x ]
Courtesy of GENERAL MOTORS COMPANY

Instrument Panel Lower Trim Panel Insulator (1) - Remove
Courtesy of GENERAL MOTORS COMPANY

Release the retaining tab.
Rotate the front floor courtesy lamp (1) a quarter turn counterclockwise to release.
Courtesy of GENERAL MOTORS COMPANY

Front Floor Courtesy Lamp (1) - Remove
Disconnect the electrical connector.
Courtesy of GENERAL MOTORS COMPANY

Using a flat-bladed plastic trim tool, release the retaining clips.
Instrument Panel Fuse Block Access Hole Cover (1) - Remove
Courtesy of GENERAL MOTORS COMPANY

Instrument Panel Trim Pad Bolt (1) - Remove
Disconnect the electrical connectors.
Instrument Panel Trim Pad (2) - Remove
Courtesy of GENERAL MOTORS COMPANY

Instrument Panel Switch Trim Plate Bolt (1) - Remove
Disconnect the electrical connectors.
Instrument Panel Switch Trim Plate (2) - Remove
Courtesy of GENERAL MOTORS COMPANY

Hood Primary Latch Release Cable Handle (1) - Release
Instrument Panel Knee Bolster Bolt (2) - Remove [ 2x ]
Courtesy of GENERAL MOTORS COMPANY

NOTE:
You may have to push down on the lower steering column closeout to clear the instrument panel cluster trim plate.

Instrument Panel Knee Bolster (1) - Remove
Courtesy of GENERAL MOTORS COMPANY

Using a small plastic trim tool, separate the instrument panel steering column upper trim cover (1) from the instrument panel steering column lower trim cover.
Courtesy of GENERAL MOTORS COMPANY

Using a small plastic trim tool, separate the instrument panel steering column upper trim cover (1) from the instrument panel steering column opening closeout (2).
Courtesy of GENERAL MOTORS COMPANY

Turn the steering wheel approximately 90 degrees to the left of the centered position.
Instrument Panel Steering Column Lower Trim Cover Bolt (1) - Remove
Courtesy of GENERAL MOTORS COMPANY

Turn the steering wheel approximately 90 degrees to the right of the centered position.
Instrument Panel Steering Column Lower Trim Cover Bolt (1) - Remove
Turn the steering wheel to the centered position.
Courtesy of GENERAL MOTORS COMPANY

Instrument Panel Steering Column Lower Trim Cover Bolt (1) - Remove
Courtesy of GENERAL MOTORS COMPANY

Instrument Panel Steering Column Lower Trim Cover (1) - Remove
Disconnect the electrical connector.
Disable the SIR system. SIR Disabling and Enabling
Courtesy of GENERAL MOTORS COMPANY

Floor Front Air Outlet Duct Bolt (1) - Remove
Courtesy of GENERAL MOTORS COMPANY

Floor Front Air Outlet Duct - Left Side (1) - Remove
Courtesy of GENERAL MOTORS COMPANY

Upper Intermediate Steering Shaft Bolt (1) - Remove
Courtesy of GENERAL MOTORS COMPANY

Upper Intermediate Steering Shaft (1) @ Steering Column (2) - Separate
Courtesy of GENERAL MOTORS COMPANY

Steering Column Nut (1) - Remove [ 4x ]
Disconnect the electrical connectors attached to the steering column.
Courtesy of GENERAL MOTORS COMPANY

Steering Column (1) - Remove
Courtesy of GENERAL MOTORS COMPANY

Steering Column Lock Control Module Bolt (1) - Remove [ 4x ]
Courtesy of GENERAL MOTORS COMPANY

Column Lock Module (1) - Remove