Programming an Existing or New Control Module
WARNING: This page is about a different car, the 2024 Chevrolet Silverado 3500 HD and 2024 Chevrolet Silverado 2500 HD. However, it is still accessible from the selected car via links, so may be relevant.
To program an existing or new control module, perform the following procedure:
- Ignition - On / Vehicle - In Service Mode
- Access SPS and follow the on-screen instructions for the control module: K69 Transfer Case Control Module
- Perform the SPS function: K69 Transfer Case Control Module - Programming
- Perform the SPS function: K69 Transfer Case Control Module - Setup
- Clear DTCs.
- Perform the scan tool Transfer Case Range Actuator Dual End Stop Learn.