Repair Procedures: Removal

CAUTION:

NOTE:

Remove the roof side molding.
(Refer to Body Side Moldings - "ROOF SIDE MOLDING ")
Remove the front pillar trim.
(Refer to Interior Trim - "FRONT PILLAR TRIM ")
Remove the inside rear view mirror assembly.
(Refer to Mirror - "INSIDE REAR VIEW MIRROR ")
Remove the cowl top cover.
(Refer to COWL TOP COVER )
Remove the A pillar garnish.
(Refer to Body Side Molding - "A PILLAR GARNISH ")
Remove the lane keeping assist system (LKAS) unit.
(Refer to LANE KEEPING ASSIST SYSTEM (LKAS) )
Using a cutter (A) knife, carefully remove the windshield glass molding.
information
- Use the cutter with a 20 to 30 cm-long blade.
Cut off the sealant on the edge (B) while pulling the piano wire (A) to the left and right.
CAUTION:
- Put on gloves to protect your hands.
- Heat may occur when working on the wires. Be careful not to burn your hands.
- Be careful not to disconnect the piano wire.
Put in a piano wire (A) through the corner of the windshield glass and insert wire grips into both ends of the wire.
Cut off the sealant on (A-A), (B-B), (C-C), while pulling a piano wire (A) to the left and right.
CAUTION:
- Put on gloves to protect your hands.
- Heat may occur when working on the wires. Be careful not to burn your hands.
- Be careful not to disconnect the piano wire.
Remove the windshield glass (B) carefully using the glass holder (A).