ETC Module Learning Procedure
WARNING: This page is about a different car, the 2016 Kia Sedona. However, it is still accessible from the selected car via links, so may be relevant.
Be sure to perform the ETC module learning procedure when replacing or re-installing the ETC module.
- Wait for 1 minute with the ignition switch ON.
- Start the engine and hold the idle status for 15 minutes.
- Waif for 1 minute with the ignition switch OFF.
- Restart the engine checking that the idle speed is stable.NOTE: The ETC module learning procedure must be performed after replacing or re-installing ETC. The ECM will set DTC's and illuminate the MIL.