ECM Neutral Mode Procedure
WARNING: This page is about a different car, the 2016 Kia Sedona. However, it is still accessible from the selected car via links, so may be relevant.
- After replacing the ECM of the vehicle with the immobilizer, the following procedure must be performed.
[If installing a used ECM]
- Perform "ECM Neutral Mode" procedure using GDS. (Refer to "Body Electrical System - "SMART KEY SYSTEM - Repair Procedures"")
- After finishing "ECM Neutral Mode", perform "Key Teaching" procedure using GDS. (Refer to "Body Electrical System - "SMART KEY SYSTEM
- Repair Procedures"")
[If installing a new ECM]
Perform "Key Teaching" procedure using GDS. (Refer to "Body Electrical System - "SMART KEY SYSTEM - Repair Procedures"")
- After replacing the ECM of the vehicle with the smart key system (button start), the following procedure must be performed.
[If installing a used ECM]
- Perform "ECM Neutral Mode" procedure using GDS. (Refer to "Body Electrical System - "SMART KEY SYSTEM - Repair Procedures"")
- After finishing "ECM Neutral Mode", turn IGN ON then OFF using the smart key or start button. Then the ECM learns information on the smart key automatically.
[If installing a new ECM]
Turn IGN ON then OFF using the smart key or start button. Then the ECM learns information on the Smart Key automatically.