Repair Procedures: Removal

WARNING: This page is about a different car, the 2017 Genesis G80. However, it is still accessible from the selected car via links, so may be relevant.

Disconnect the battery negative cable and wait for at least three minutes before beginning work.
Put a flat tool (Ø4mm) into a guide hole located in the bottom of steering wheel and press a spring.

Courtesy of

Courtesy of

CAUTION: When put a tool into a hole, make sure not to damage an airbag cushion by a tool.
Turn a steering wheel anti-clockwise, so make a guide hole (A) shown on the right side in illustration below.
Put a tool into a hole (B) and bend back a fixed DAB spring.

Make sure to pull DAB cover when bend back the spring.

Courtesy of

Courtesy of

Courtesy of

NOTE: Pull the DAB cover when disengaging the DAB spring because the DAB does not pop up automatically.
Turn a steering wheel clockwise. Put a tool into a hole (B) and bend back a fixed DAB spring. Make sure to pull DAB cover when

Courtesy of

Courtesy of

CAUTION: Be careful not to put a tool into a wrong hole.
Remove the steering wheel.
(Refer to Steering System - "Steering Column and Shaft ")
Loosen the steering wheel column cover mounting screws and remove the cover.

Courtesy of

CAUTION: Be careful not to put a tool into a wrong hole.
Disconnect the clock spring and horn connector, then remove the clock spring.

Courtesy of