DTC Information: DTC Detecting Condition

Item		Detecting Condition	Possible Cause
Case 1	Main Action	Level 2 process monitoring	Contact resistance in connectors Faulty ECM
	Prerequisite condition	Ignition switch is turned "ON" or engine is running.
	Threshold Value	Engine speed under ETC limp home activation is higher than 1760 rpm. Difference between actual and targeted torque is higher than 22 to 400Nm. (torque monitoring error)
	Diagnosis Time	0.52 Seconds
Case 2	Main Action	Check RAM area and communication connections
	Prerequisite condition	Ignition switch is turned "ON".
	Threshold Value	RAM test/checksum/SPI communication failure
	Diagnosis Time	0.1 Seconds
Case 3	Main Action	Level 3 process monitoring
	Prerequisite condition	Ignition switch is turned "ON".
	Threshold Value	RAM/ROM error on microcontroller. Process monitoring test calculation failed
	Diagnosis Time	Immediately
MIL On Condition		2nd Driving Cycle