LEMON Manuals: Even more car manuals for everyone: 1960-2025
Home >> Genesis >> 2019 >> G70 3.3T Dynamic, AWD >> Repair and Diagnosis >> Brakes >> Traction Control >> Electronic Stability Control Diagnosis >> DTC C1702-04: Variant Coding Error >> Component Inspection
April 5, 2026: LEMON Manuals is launched! Read the announcement.

Component Inspection

  1. Turn "Off" the ignition switch.
  2. Turn "On" the ignition switch.
  3. Connect GDS and select "Diagnostic Trouble Codes (DTCs)" mode.
  4. Using a GDS, and clear DTC.
  5. Select "Diagnostic Trouble Codes (DTCs)" mode again.
  6. Are any DTCs present?

    YES 

    • Replace it with a new ESP (ESC) and check for proper operation. If problem is corrected, place the new ESP (ESC) and then go to "VERIFICATION OF VEHICLE REPAIR " procedure.

    NO 

    • Fault can be intermittent, caused by faulty ESP (ESC). Or, ESP (ESC) memory was not cleared after repair. Go to "VERIFICATION OF VEHICLE REPAIR " procedure.
NOTE: * In a case of replacing ESP (ESC), perform following functions
  1. "Steering Angle Sensor Calibration" for steering angle sensor offset correction (refer to C126104 ) -ESP (ESC) only
  2. "Longitudinal Sensor Calibration" for Longitudinal sensor offset correction (refer to C128504 ) - ESP (ESC) only
  3. "Variant Coding" for option coding (refer to C170204 )
scientia non olet · About LEMON Manuals