LEMON Manuals: Even more car manuals for everyone: 1960-2025
Home >> Genesis >> 2019 >> G80 3.8, AWD >> Repair and Diagnosis >> Body & Frame >> Seats >> Front Seat Assembly >> Front Seat Frame Assembly >> Repair Procedures >> Replacement
April 5, 2026: LEMON Manuals is launched! Read the announcement.

Repair Procedures: Replacement

CAUTION:
  • Put on gloves to prevent hand injuries.
NOTE:
  • When removing with a flat-tip screwdriver or remover, wrap protective tape around the tools to prevent damage to components.
  • When removing the interior trim pieces, use a plastic panel removal tool not to damage the surface.
  • Take care not to bend or scratch the trim and panels.
  1. Remove the front seat back cover.

    (Refer to Front Seat - "FRONT SEAT BACK COVER ")

  2. Remove the front seat cushion cover.

    (Refer to Front Seat - "FRONT SEAT CUSHION COVER ")

  3. Remove the mounting bolt (A).
    G12658272Courtesy of HYUNDAI MOTOR AMERICA
  4. Disconnect the connector (A).
  5. After loosening the mounting bolts, remove the front seat cushion extension cushion modules (B).
    G12658273Courtesy of HYUNDAI MOTOR AMERICA
  6. After loosening the mounting screws, remove the cushion extension lower cover (A).
    G12658274Courtesy of HYUNDAI MOTOR AMERICA
  7. After loosening the mounting bolts, detach the front seat back frame assembly (A) from the front seat cushion frame assembly (B).
    G12658275Courtesy of HYUNDAI MOTOR AMERICA
  8. Install in the reverse order of removal.

    Information 

    • For the seat equipped with side airbag, remove the side airbag from the seat frame assembly.

      (Refer to Restraint - "SIDE AIRBAG (SAB) MODULE ")

    • Before service, be fully aware of precautions and service procedure relevant to air bag.

      (Refer to Restraint - "SIDE AIRBAG (SAB) MODULE ")

scientia non olet · About LEMON Manuals