(Button Start System Removal And Installation)
Abbreviated Procedures
| Work | H/W | Tightening torque N.m (kgf.m/lb-ft) | SST/Equipment | Chemical | etc | |
|---|---|---|---|---|---|---|
|
||||||
| 1 | Disconnect the battery negative (-) terminal | - | - | Diagnostic tool | - | |
| 2 | Remove the steering column shroud upper panel | Fastener | - | - | - | - |
| 3 | Remove the front door body side weather strip | - | - | - | - | - |
| 4 | Remove the crash pad side cover [RH] | Fastener | - | - | - | - |
| 5 | Open the glove box | - | - | - | - | - |
| 6 | Pull out the both sides stopper | - | - | - | - | - |
| 7 | Remove the lock pin and then remove the air damper | - | - | - | - | - |
| 8 | Remove the glove box lock pins | - | - | - | - | - |
| 9 | Remove the glove box | - | - | - | - | - |
| 10 | Remove the crash pad under cover [RH] | - | - | - | - | - |
| 11 | Disconnect the foot lamp connector | - | - | - | - | - |
| 12 | Remove the heater & A/C control unit (DATC) | Fastener/Screw | - | - | - | - |
| 13 | Disconnect the heater & A/C control unit (DATC) connectors | - | - | - | - | - |
| 14 | Remove the crash pad garnish [RH] | Fastener/Screw | - | - | - | - |
| 15 | Disconnect the audio & AVN keyboard connector | - | - | - | - | - |
| 16 | Disconnect the mood lamp connector | - | - | - | - | - |
| 17 | Disconnect the SSB connector | - | - | - | - | - |
| 18 | Disconnect the incar sensor | - | - | - | - | - |
| 19 | Remove the Start/Stop Button | Screw | - | - | - | - |
|
||||||
| Install in the reverse order of removal | ||||||
|
||||||