(Occupant Classification System (OCS) Removal And Installation)

Abbreviated Procedures

Work		H/W	Tightening torque N.m (kgf.m/lb-ft)	SST/Equipment	Chemical	etc
Removal
1	Shut off the high voltage circuit	-	-	Diagnostic tool	-	-
2	Remove the front anchor seat belt	-	-	-	-	-
3	Remove the front seat assembly	Bolt	49.0 - 63.7 (5.0 - 6.5/36.2 - 47.0)	-	-	-
4	Disconnect the front seat connector	-	-	-	-	-
5	Remove the front seat shield front cover	Screw	-	-	-	-
6	Remove the front seat outer shield cover	-	-	-	-	-
7	Disconnect the front seat power switch connector	-	-	-	-	-
8	Remove the front seat shield inner cover	-	-	-	-	-
9	Remove the front seat headrest	-	-	-	-	-
10	Disconnect the center airbag connector	-	-	-	-	-
11	Disconnect the side airbag connector	-	-	-	-	-
12	Remove the front seat lower protector	-	-	-	-	-
13	Disconnect the front seat heater connector	-	-	-	-	-
14	Remove the front seat back board	Hook	-	-	-	Refer to SHOP repair information
15	Disconnect the ergo motion seat connector	-	-	-	-	-
16	Disconnect the ergo motion seat tube	-	-	-	-	-
17	Remove the mounting bolts, detach the front seat back frame and front seat cushion frame	Bolt	44.1 - 53.9 (4.5 - 5.5/32.5 - 39.8)	-	-	-
18	Remove the front seat cushion cover assembly	-	-	-	-	-
19	Remove the front seat cushion cover protector [Upper/Lower/LH/RH]	-	-	-	-	-
20	Remove the front seat cushion cover assembly	-	-	-	-	-
21	Remove the velcro tape inside the front seat cushion cover	-	-	-	-	-
22	Remove the hog-ring clips inside the front seat cushion cover	Hog-ring	-	09880-4F000	-	-
23	Remove the front seat cushion cover	-	-	-	-	-
24	Remove the OCS sensor	-	-	-	-	-
Installation
Install in the reverse order of removal
Additional work