SRS Control Module (SRSCM): Installation

Install in the reverse of the removal.
After installing the SRSCM, confirm proper system operation.
NOTE:
- If the Switch ON the ignition, the SRS indicator light should turn on for about six seconds and then off.
Information
- Turn the power switch ON; the SRS indicator light should be turned on for about 3~6 seconds and then go off.
- Make sure the connector is connected properly.
- After installing the SRSCM, Carry out variant coding and longitudinal G-sensor calibration.
  (Refer to SRS Control Module (SRSCM) - "VARIANT CODING ")