LEMON Manuals: Even more car manuals for everyone: 1960-2025
Home >> Genesis >> 2023 >> G80 2.5T Advanced, AWD >> Repair and Diagnosis >> External Pages >> Different car >> Section 121 (Airbag Module And Clock Spring) >> Curtain Airbag (CAB) Module >> Repair Procedures >> Installation
April 5, 2026: LEMON Manuals is launched! Read the announcement.

Repair Procedures: Installation

WARNING: This page is about a different car, the 2024 Genesis G80. However, it is still accessible from the selected car via links, so may be relevant.
  1. Disconnect the negative (-) battery terminal.
    WARNING:
    • Disconnect the battery negative cable, and wait for at least three minutes before beginning work.
  2. Tighten the curtain airbag mounting bolts.

    Tightening torque 

    Bolts: 19.6 - 29.4 N.m (2.0 - 3.0 kgf.m, 14.5 - 21.7 lb-ft)

    Nuts: 9.8 - 14.7 N.m (1.0 - 1.5 kgf.m, 7.2 - 10.8 lb-ft)

    CAUTION:
    • Never twist the airbag module when installing it. If the module is twisted, the airbag module may operate abnormally.
  3. Connect the curtain airbag connector.
  4. Install the roof trim assembly.

    (Refer to Body (Interior and Exterior) - "ROOF TRIM ASSEMBLY ")

  5. Reconnect the negative (-) battery terminal.
  6. After installing the curtain airbag (CAB), confirm proper system operation.
    NOTE:
    • Turn the ignition switch ON; the SRS indicator light should turn on for about 3-6 seconds and then go off.
scientia non olet · About LEMON Manuals