July 1: So it begins. Don't worry, this is not in the correct legal jurisdiction!

Removal And Installation

WARNING: This page is about a different variant/trim than selected.

Switch "OFF" the ignition and disconnect the battery negative (-) terminal.
Disconnect the accelerator position sensor connector (A).
Disconnect the upper mounting cap (B), and remove the mounting nut (C).
Disconnect the lower mounting cap (D), and remove the mounting bolt (E).
Tightening torque:

8.8 - 13.7 N.m (0.9 - 1.4 kgf.m, 6.5 - 10.1 lb-ft)

Courtesy of HYUNDAI MOTOR AMERICA

Courtesy of HYUNDAI MOTOR AMERICA
Install in the reverse order of removal.