Fuel System Pressure Release
CAUTION:
DO NOT
perform this procedure when the engine is hot. Doing so may have an adverse effect on the catalytic convertor.
- Place transmission in Neutral (M/T) or Park (A/T). Set parking brake and block drive wheels.
- Disconnect fuel pump relay, located under left side of dash, left of ECM. See Fig 1. Remove fuel filler cap to release fuel vapor pressure in fuel tank.
- Reinstall fuel filler cap. Start engine and run until engine dies. After engine dies, crank engine 2-3 times for about 3 seconds to dissipate fuel pressure in lines. To restore normal operation, reconnect fuel pump relay connector.