Power Steering Pressure Switch: Service and Repair

POWER STEERING PRESSURE SWITCH REPLACEMENT

REMOVE OR DISCONNECT
1. Negative (-) battery cable.
2. Power Steering Pressure (PSP) switch electrical connector.
3. PSP switch from power steering pump.

INSTALL OR CONNECT
1. PSP switch to power steering pump. Tighten PSP switch to 27 Nm (20 lb. ft.).
2. PSP switch electrical connector.
3. Negative (-) battery cable. Tighten Negative (-) battery cable-to-negative (-) battery terminal retainer to 15 Nm (11 lb. ft.).