Shift Control Cable
- Start engine and move shift lever into "R" position. See if transaxle engages in Reverse. With engine off, remove center console.
- Move shift lever into "N" or "R" position. Remove lock pin from adjuster. Ensure adjuster and shift cable holes align perfectly. See Fig 1
.
- Holes in end of adjuster are positioned to allow cable adjustments in 1/4 turn increments. If not perfectly aligned, adjust shift cable.
- Loosen lock nut and adjust as necessary. Tighten lock nut. Install lock pin into adjuster. See Fig 1
.
- Lock pin should not bind during installation. Start engine and check shift lever in all gears. Vehicle should only start in "P" and "N" positions. Adjust neutral safety switch (if necessary). Reverse removal procedure to install center console.
Courtesy of AMERICAN HONDA MOTOR CO., INC.