EGR Monitor
NOTE:
Do not turn ignition off. When negative battery cable is disconnected, all readiness test codes are cleared.
- Connect scan tool to DLC. Start engine, and hold at 3000 RPM under no load condition with transaxle in Park or Neutral until radiator cooling fan comes on.
- Drive vehicle at a steady speed between 50-62 MPH with transaxle in D position with overdrive ON (5th gear on M/T) for more than 10 seconds.
- With transaxle in D position with overdrive ON (5th gear on M/T), decelerate from 62 MPH by completely releasing throttle for at least 5 seconds. If engine is stopped, go back to step 2 and start over. Check for readiness code with scan tool.