Transfer Assembly Reassembly: Notes

Special Tools Required 

• Holder handle 07JAB-001020A
• Oil seal driver attachment 07JAD-PH80101
• Companion flange holder 07PAB-0020000
• Attachment, 72 x 75 mm 07746-0010600
• Driver, 40 mm I.D 07746-0030100
• Attachment, 35 mm I.D 07746-0030400
• Driver 07749-0010000

Note these items during reassembly:

• While reassembling the transfer assembly:
  • Check and adjust the transfer gear tooth contact.
  • Measure and adjust the transfer gear backlash.
  • Check and adjust the tapered roller bearing starting torque.
• Coat all parts with MTF during reassembly.
• Replace the tapered roller bearing and the bearing outer race as a set if either part is replaced.
• Replace the transfer drive gear and the transfer driven gear shaft as a set if either part is replaced.