Shift Lock Solenoid/Shift Lock Stop/Shift Lock Stop Cushion Replacement
- Remove the shift lever assembly (see
SHIFT LEVER REMOVAL ).
- Remove the tape from the harness.
- Remove the harness band.
Courtesy of AMERICAN HONDA MOTOR CO., INC.
- Remove the shift lock solenoid (A) by expanding its locks (B). Remove the shift lock solenoid plunger (C) and plunger spring (D).
Courtesy of AMERICAN HONDA MOTOR CO., INC.
- If replacing the shift lock stop or shift lock stop cushion, remove the shift lock stop (E), and remove the shift lock stop cushion (F).
- Replace the shift lock solenoid.
- Apply silicone grease to the pin (G) on the shift lever bracket, and install the shift lock stop over the pin. Be sure to install the shift lock stop cushion on the stop.
- Install the shift lock solenoid plunger and plunger spring in the shift lock solenoid.
- Apply silicone grease to the tip of the shift lock stop, and install the shift lock solenoid by aligning the joint of the shift lock solenoid plunger with the tip of the shift lock stop.
- Route the harnesses along the harness guide (A), and tie the harnesses and guide with the new band (B).
Courtesy of AMERICAN HONDA MOTOR CO., INC.
- Tie the harnesses together into bundles with new tape (A) in two places.
Courtesy of AMERICAN HONDA MOTOR CO., INC.
- Tie the harnesses and the harness clamp (B) together into a bundle with tape (C).
- Install the shift lever assembly (see
SHIFT LEVER INSTALLATION ).