LEMON Manuals: Even more car manuals for everyone: 1960-2025
Home >> Honda >> 2007 >> Element SC, Automatic >> Repair and Diagnosis >> General Information >> Specifications Index >> Common Specs & Procedures >> Common Specs & Procedures Index
April 5, 2026: LEMON Manuals is launched! Read the announcement.

Common Specs & Procedures Index

ELEMENT COMMON SPECS & PROCEDURES INDEX

System Specification/Procedure
Air Conditioning
Service AIR CONDITIONING
Torque See applicable component in HVAC article.
Axle Nut/Hub Nut
Front 245 N.m (181 ft. lbs.)
Rear 181 N.m (134 ft. lbs.)
Battery BATTERY
Brakes
Bleeding Sequence BRAKE SYSTEM BLEEDING
Disc Brakes BRAKE SYSTEM SERVICE SPECIFICATIONS
Torque See applicable component in CONVENTIONAL BRAKE COMPONENTS article.
Charging
Generator ENGINE ELECTRICAL SERVICE SPECIFICATIONS
Torque See applicable figure in ALTERNATOR REMOVAL AND INSTALLATION .
Drive Belts
Adjustment DRIVE BELT INSPECTION
Belt Routing COMPONENT LOCATION INDEX & DRIVE BELT ROUTING
Engine Cooling
General Service Specifications ENGINE COOLING SERVICE SPECIFICATIONS
Radiator Cap Pressure 93-123 kPa (0.95-1.25 kgf/cm2 , 14-18 psi)
Thermostat R & I THERMOSTAT REPLACEMENT
Water Pump R & I WATER PUMP REPLACEMENT
Engine Mechanical
Compression ENGINE SERVICE SPECIFICATIONS
Oil Pressure (176°F (80°C) 70 kPa (.7 kgf/cm2 , 10 psi) @ idle; 300 kPa (3.1 kgf/cm2 , 44 psi) @ 3000 RPM
Overhaul See applicable specifications table in.ENGINE SERVICE SPECIFICATIONS
Torque See applicable component in one of the following articles:
CYLINDER HEAD
ENGINE BLOCK
ENGINE LUBRICATION
INTAKE MANIFOLD AND EXHAUST SYSTEM
Fluid Specifications See FLUIDS under MAINTENANCE tab.
Flywheel/Flex Plate Torque
M/T 103 N.m (76 ft. lbs.)
A/T 74 N.m (54 ft. lbs.)
Fuel System
Pressure Specification 330-380 kPa (3.4-3.9 kgf/cm2 , 48-55 psi)
Fuel Pressure Test Procedure FUEL PRESSURE TEST
Ignition
Firing Order & Cylinder Identification FIRING ORDER & CYLINDER IDENTIFICATION
Ignition Wires (Resistance) NA
Ignition Wires (Routing) NA
Spark Plug (NGK: IZFR6K-11; DENSO: SKJ20DR-M11
Gap 1.0-1.1 mm (.039-.043 in.)
Torque 18 N.m (13 ft. lbs.)
Starting
Starter STARTER PERFORMANCE TEST
Torque STARTER REMOVAL AND INSTALLATION
Wheel Alignment
Adjustment Specifications SUSPENSION SERVICE SPECIFICATIONS
Torque
Front See applicable component in FRONT SUSPENSION article.
Rear See applicable component in REAR SUSPENSION article.
Wheel & Tire
Wheel Lug Nut Torque 108 N.m (80 ft. lbs.)