Data List/Active Test
WARNING: This page is about a different car, the 2007 Toyota Tacoma. However, it is still accessible from the selected car via links, so may be relevant.
- READ DATA LIST
HINT:
Using the intelligent tester's DATA LIST allows switch, sensor, actuator and other item values to be read without removing any parts. Reading the DATA LIST early in troubleshooting is one way to save time.
- Connect the intelligent tester to the DLC3.
- Turn the ignition switch ON.
- Read the DATA LIST.
Transponder key ECU assembly
DATA LISTItem Measurement Item / Display (Range) Normal Condition Diagnostic Note KEY SW Unlock warning switch signal / ON or OFF ON: Key is in ignition key cylinder
OFF: No key is in ignition key cylinder- IG SW Ignition switch signal / ON or OFF ON: Ignition switch ON
OFF: Ignition switch OFF or ACC- IMMOBILIZER Immobilizer system status / SET or UNSET SET: Without key
UNSET: Ignition switch ON- PERMIT (START) Start control system starting control / OK or NG OK: Start control system starting is permitted
NG: Start control system starting is not permitted- RESPONSE Transponder chip data / OK or NG OK: Data OK
NG: Data error- FRAME Transponder chip data / OK or NG OK: Data OK
NG: Data error- SERIAL NUMBER Transponder chip signal / OK or NG OK: Data OK
NG: Data error- ENCRYPT CODE Transponder chip signal / OK or NG OK: Data OK
NG: Data error- STATUS Transponder chip signal / OK or NG OK: Data OK
NG: Data error- BCC Transponder chip signal / OK or NG OK: Correct data sending
NG: Incorrect data sending- SUB KEY Sub-key code signal / NO MATCH or MATCH NO MATCH: Unmatched sub-key code is sent
MATCH: Sub-key code is sent- MASTER KEY Master key code signal / MATCH or NO MATCH NO MATCH: Unmatched sub-key code is sent
MATCH: Sub-key code is sent- REGIST SUB CODE Number of registered sub - key / min. 0, max. 15 Number of registered sub-keys - REGIST MAS CODE Number of registered master key / min. 0, max. 15 Number of registered master keys - REG CODE SPACE Memory space for key codes registration / NOT FUL or FULL NOT FUL: Possible to register more key codes
Full: Cannot register any more key codes- +B +B judgment / NORMAL or BREAK NORMAL: Battery supply is normal
BREAK: Battery supply is malfunctioning- ANTENNA COIL Antenna coil condition / NORMAL or FAIL NORMAL: Antenna coil is normal
FAIL: Antenna coil is malfunctioning- G-CODE SUPPORT G code judgment / NOT SUPPORT or SUPPORT NOT SUPPORT: G-code is not supported
SUPPORT: G-code is supported- G-CODE DECISION G code judgment / YES or NO - - WIRELS C-CODE REGD or NOT REGD - -
- PERFORM ACTIVE TEST
HINT:
Perform the intelligent tester's ACTIVE TEST allows relay, VSV, actuator and other items to be operated without removing any parts. Performing the ACTIVE TEST early in troubleshooting is one way to save time. The DATA LIST can be displayed during the ACTIVE TEST.