Exploded View

WARNING: This page is about a different car, the 2008 Honda Pilot, 2007 Honda Pilot, and 2006 Honda Pilot. However, it is still accessible from the selected car via links, so may be relevant.

Fig 1: Exploded View Of Parking Brake Cable Components With Torque Specifications

Courtesy of AMERICAN HONDA MOTOR CO., INC.

NOTE:

The parking brake cable must not be bent or distorted. This will lead to stiff operation and premature cable failure.
Refer to the EXPLODED VIEW as needed during this procedure.

Remove the parking brake shoes, and disconnect the parking brake cable from the brake shoe (see PARKING BRAKE SHOE REPLACEMENT ).
Remove the parking brake cable (A) from the backing plate (B) using a 12 mm offset wrench (C).

Fig 2: Removing Parking Brake Cable From Backing Plate Using Offset Wrench
Courtesy of AMERICAN HONDA MOTOR CO., INC.
Reinstall the parking brake cable in the reverse order of removal, and note these items:
- Before installing the brake disc/drum, clean the mating surfaces of the rear hub and the inside of the brake disc/drum.
- Before installing the wheel, clean the mating surfaces on the brake disc/drum and the inside of the wheel.
- Adjust the parking brake (see BRAKE PEDAL AND BRAKE PEDAL POSITION SWITCH ADJUSTMENT ). Apply the parking brake firmly 10 times, then adjust it again.