Navigation Unit Removal/Installation

NOTE:

Before you replace the navigation unit, back-up the customer data using system diagnostic mode "save users memory" ('07 and later) under the functional set up (see SAVE USERS MEMORY ).
If the navigation unit is replaced or disconnected, a Map Matching must be done (see MAP MATCHING ).

Turn the ignition switch ON (II).
Eject the DVD from the original navigation unit (see FORCED STARTING OF DISPLAY ). To avoid scratching or damaging the DVD, temporarily place the DVD in a jewel case.
Turn the ignition switch OFF.
Remove the bolts, then pull out the navigation unit (A).

Fig 1: Identifying Navigation Unit, Harness Connectors And Fasteners
Courtesy of AMERICAN HONDA MOTOR CO., INC.
Disconnect the connectors (B), then remove the navigation unit.
Remove the screws and the bracket (A).

Fig 2: Removing Brackets From Navigation Unit
Courtesy of AMERICAN HONDA MOTOR CO., INC.
Install the navigation unit in the reverse order of removal.
Turn the ignition switch ON (II), then reinstall the customer's original DVD, verifying that the DVD is free of scratches or smudges.
Check on-line for any service publications prescribing patches for the navigation system, and if any should be applied to the new navigation unit.
NOTE: Simply transferring the DVD from the original navigation unit to the new navigation unit does not assure the correct software for the vehicle will be loaded into the new navigation unit. Doing the DVD transfer without doing software patches may cause the new navigation unit to appear to be malfunctioning.
Enter the new navigation anti-theft code.
Park the vehicle outside, and do the GPS initialization (see GPS INITIALIZATION ).
Give the new navigation anti-theft code to the customer.