TPMS Reset Procedures: Notes
NOTE:
When a tire pressure sensor or control unit is replaced, or a known good wheel is substituted, the ID(s) of all four tires' sensors must be memorized by the TPMS control unit. See Memorizing Sensor ID . After memorizing the sensor ID(s) or doing a tire rotation, the mounting location of sensors 1, 2, 3 and 4 must be determined. When the "activate sensor" signal is sent to each wheel using the ATEQ VT55 tool (mandatory for the Crosstour), or the TPMS sensor tool AKS0620006 in sequence, the tire pressure sensors can be located by the reaction sensor number. See Sensor Location .
NOTE:
The Honda Diagnostic System (HDS) or an OBD-II compatible scan tool and an ATEQ VT55 tool (mandatory for the Crosstour), or the TPMS sensor tool AKS0620006 must be used to program information into new TPMS control unit with both of the reset procedures.
If low tire pressure indicator is lit continuously due to low pressure in one or more tires, adjust tire inflation to proper pressure as indicated on the tire and loading information placard. The light will go out once the tire pressure is properly set, and the vehicle is driven above 28 mph.