Run the Sensor Input Display Mode: Notes

Turn the ignition switch to LOCK (0).
Press and hold both the AUTO and RECIRCULATION buttons, then start the engine.
After the engine starts, release both buttons. The display panel control unit will flash the sensor number and then the value for that sensor. Record the value displayed.

To advance to the next sensor, press the REAR WINDOW DEFOGGER/MIRROR HEATER button.

NOTE:

The sensor values will be displayed in degrees Celsius (°C) or an alphanumeric code. Use the chart to convert the value to degrees Fahrenheit (°F).
If the sensor value displays "Er" this indicates there is an open or short in the circuit or sensor. Check for DTCs using the HDS, or use the climate control self-diagnostic function.
If necessary, compare the sensor input display to a known-good vehicle under the same test conditions.
If the sensor is out of the normal range, refer to the sensor test or substitute a known-good sensor, and recheck.

SENSOR INPUT DISPLAY MODE REFERENCE

Sensor	Item	Displayed Value
1	Mode positioning	BIT
2	In-car temperature	°C
3	Outside air temperature	°C
4	Solar radiation sensor value: dark = 00, flashlight = 04, cloudy = 10, sunny = 65	10kcal/m+² .h
5	Evaporator outlet air temperature	°C
6	Air mix opening (low value indicates cooler air distribution, higher value indicates warmer air distribution)	% of opening
7	Vehicle speed (vehicle must be driven to display speed)	10km/h
8	Engine coolant temperature	°C
9	Vent temperature air out (TAO)	°C
A	Humidity sensor value	%
b	Illumination duty	Step
C	Auto idle stop prohibit flag	--
d	Software version	--