Door Key Cylinder Switch Test
- Remove the driver's door panel (see
DOOR PANEL REMOVAL/INSTALLATION
).
- Disconnect the 10P connector (A) from the door latch (B).
Courtesy of AMERICAN HONDA MOTOR CO., INC.
- Check for continuity between the terminals.
- There should be continuity between terminals No. 7 and No. 10 when the door key cylinder switch is in the UNLOCK position.
- There should be no continuity between terminals No. 7 and No. 10 when the door key cylinder switch is in the neutral or LOCK position.
- There should be continuity between terminals No. 6 and No. 10 when the door key cylinder switch is in the LOCK position.
- There should be no continuity between terminals No. 6 and No. 10 when the door key cylinder switch is in the neutral or UNLOCK position.
- There should be no continuity between terminals No. 7 and No. 6 when the key is in the neutral position.
- If the continuity is not as specified, replace the driver's door latch (see
DOOR LATCH REPLACEMENT
).