VSA Modulator-Control Unit Removal and Installation: Installation
WARNING: This page is about a different car, the 2011 Honda Fit, 2010 Honda Fit, and 2009 Honda Fit. However, it is still accessible from the selected car via links, so may be relevant.
- Install the VSA modulator-control unit onto the bracket.
- Install the bracket with the VSA modulator-control unit to the body.
- Reconnect the six brake lines, then tighten the flare nuts to the specified torque.
- Align the connecting surface of the VSA modulator-control unit 36P connector to the VSA modulator-control unit.
- Pull up the lever of the VSA modulator-control unit 36P connector, then confirm the connector is fully seated.
- Install the washer reservoir (see WASHER RESERVOIR REPLACEMENT ).
- Bleed the brake system (see BRAKE SYSTEM BLEEDING ).
- Do VSA MODULATOR-CONTROL UNIT UPDATE .
- Do VSA SENSOR NEUTRAL POSITION MEMORIZATION procedure.