LEMON Manuals: Even more car manuals for everyone: 1960-2025
Home >> Honda >> 2012 >> Insight Base >> Repair and Diagnosis >> External Pages >> Different car >> Section 30 (Engine Assembly) >> Torque Rod Replacement
April 5, 2026: LEMON Manuals is launched! Read the announcement.

Torque Rod Replacement

WARNING: This page is about a different car, the 2011 Honda Insight and 2010 Honda Insight. However, it is still accessible from the selected car via links, so may be relevant.
  1. Raise the vehicle on the lift to full height.
  2. Support the transmission with a jack and a wood block under the transmission.
  3. Remove the torque rod (A).
    NOTE: Make sure the tab (B) on the bolt head aligned with the guide (C) on the front subframe.
    Fig 1: Torque Rod , Guide Plate With Torque Specifications And Guide
    G06428833Courtesy of AMERICAN HONDA MOTOR CO., INC.
  4. Install the torque rod (A).
    NOTE: Be sure to install the torque rod with the "UP" mark facing up.
  5. Install the bolt with the tab (B) on the bolt head aligned with the guide (C) on the front subframe, then tighten the new torque rod mounting bolt and nut in the numbered sequence shown.
  6. Remove the transmission jack and wood block from under the transmission.
  7. Lower the vehicle on the lift.
scientia non olet · About LEMON Manuals