Common Specs & Procedures
INSIGHT COMMON SPECS & PROCEDURES
| System | Specification/Procedure | ||||
|---|---|---|---|---|---|
| Air Conditioning | |||||
| Service | AIR CONDITIONING | ||||
| Torque | See applicable component in HEATING, VENTILATION AND AIR CONDITIONING article. | ||||
| Axle Nut/Hub Nut | |||||
| Front | 181 N.m (134 ft. lbs.) | ||||
| Rear | 181 N.m (134 ft. lbs.) | ||||
| Battery | 12 VOLT BATTERY | ||||
| Brakes | |||||
| Bleeding Sequence | BRAKE SYSTEM BLEEDING | ||||
| Disc Brakes | BRAKES | ||||
| Drum Brakes | BRAKES | ||||
| Torque | See applicable component in CONVENTIONAL BRAKE COMPONENTS article. | ||||
| Charging | |||||
| Generator | ENGINE ELECTRICAL | ||||
| Torque | N/A | ||||
| Drive Belts | |||||
| Adjustment | DRIVE BELT INSPECTION | ||||
| Belt Routing | DRIVE BELT REPLACEMENT | ||||
| Engine Cooling | |||||
| General Service Specifications | COOLING SYSTEM | ||||
| Radiator Cap Pressure | 93-123 kPa (0.95-1.25 kgf/cm2 14-18 psi) | ||||
| Thermostat R & I | THERMOSTAT REPLACEMENT | ||||
| Water Pump R & I | WATER PUMP REPLACEMENT | ||||
| Engine Mechanical | |||||
| Compression | ENGINE ASSEMBLY | ||||
| Oil Pressure (176°F (80°C)) | 70 kPa (0.7 kgf/cm2
, 10. psi) @ idle 340 kPa (3.5 kgf/cm2 , 50 psi) @ 3000 RPM |
||||
| Overhaul | See applicable specifications table in ENGINE SERVICE SPECIFICATIONS . | ||||
| Torque | See applicable component in one of the following articles: CYLINDER HEAD ENGINE BLOCK ENGINE LUBRICATION SYSTEM INTAKE MANIFOLD AND EXHAUST SYSTEM |
||||
| Fluid Specifications | See FLUIDS under MAINTENANCE tab. | ||||
| Flex Plate Torque (A/T) | 44 N.m (33 ft. lbs.) | ||||
| Fuel System | |||||
| Pressure Specification | 260-310 kPa (2.7-3.2 kgf/cm2 , 38-46 psi) | ||||
| Fuel Pressure Test Procedure | FUEL PRESSURE TEST | ||||
| Fuel Filter Location |
|
||||
| Ignition | |||||
| Firing Order & Cylinder Identification | FIRING ORDER & CYLINDER IDENTIFICATION | ||||
| Ignition Wires (Resistance) | N/A | ||||
| Spark Plug (NGK:DILFR6F11G) | |||||
| Gap | 1.0-1.1 mm (.039-.043 in.) | ||||
| Torque | 18 N.m (13 ft. lbs.) | ||||
| Starting | |||||
| Starter | STARTER PERFORMANCE TEST | ||||
| Torque | STARTER REMOVAL AND INSTALLATION | ||||
| Wheel Alignment | |||||
| Adjustment Specifications | SUSPENSION | ||||
| Torque | |||||
| Front | See applicable component in FRONT SUSPENSION article. | ||||
| Rear | See applicable component in REAR SUSPENSION article. | ||||
| Wheel & Tire | |||||
| Wheel Lug Nut Torque | 108 N.m (80 ft. lbs.) | ||||