Component Replacement/Inspection After Deployment: Notes
NOTE:
- Before doing any SRS repairs, check the DTCs (see DTC (DIAGNOSTIC TROUBLE CODES) ), for the less obvious deployed components (seat belt tensioners, front impact sensors, side impact sensors, etc.).
- If there is a breaking or damage found in harness relevant to the replacement parts shown below, replace it, do not repair.
- Do not replace the ODS unit unless it is physically damaged or a specific fault was found during DTC troubleshooting. Because it could complicate troubleshooting other DTCs.
- After a vehicle collision, do the ODS unit operation check (see ODS UNIT OPERATION CHECK ).
- After a vehicle collision, inspect the front seat active head restraint (see FRONT SEAT ACTIVE HEAD RESTRAINT INSPECTION ).
After a collision where the seat belt tensioners deployed, replace these items:
- SRS unit
- Seat belt tensioners
- Front impact sensors
After a collision where the front airbag(s) deployed, replace these items:
- SRS unit
- Deployed airbag(s)
- Seat belt tensioners
- Front impact sensors
After a collision where the side airbag(s) deployed, replace these items:
- SRS unit
- Deployed side airbag(s)
- Side impact sensor(s) (first)
- Side impact sensor(s) (second)
- Rear safing sensor
- Seat frame(s) and related parts
After a collision where a side curtain airbag has deployed, replace the items for the side(s) that deployed:
- SRS unit
- Deployed side curtain airbag(s)
- Side impact sensor(s) (first)
- Side impact sensor(s) (second)
- Rear safing sensor
- A-pillar trim(s)
- B-pillar upper trim(s)
- C-pillar trim(s)
- Headliner
- Front grab handle(s)
- Rear grab handle(s)
- All related trim clips
- Sunvisor(s)
After a moderate to severe side or rear collision, inspect for any damage on the side curtain airbag or other related components. Replace the components as needed.