DTC 53-FF: SRS Unit Programming Error
NOTE:
- Before doing this troubleshooting procedure, find out if the vehicle was in a collision. If so, verify that all the required components were replaced with new components, of the correct part number, and that they were properly installed (see COMPONENT REPLACEMENT/INSPECTION AFTER DEPLOYMENT ).
- This DTC is indicated when a SRS unit update is not completed properly.
- Do not turn the ignition switch to ACC (I) or to LOCK (0) while updating the SRS unit. If you turn the ignition switch to ACC (I) or to LOCK (0) before you complete the SRS unit update procedure, the SRS unit can be damaged.
- Before doing this troubleshooting procedure, review SRS Precautions and Procedures (see PRECAUTIONS AND PROCEDURES ), General Troubleshooting Information (see GENERAL TROUBLESHOOTING INFORMATION ), and 12 Volt Battery Terminal Disconnection and Reconnection (see USING THE GR8 BATTERY DIAGNOSTIC STATION ).
- Do the SRS unit update procedure (see SRS UNIT UPDATE ).
- Check for DTCs with the HDS (see HOW TO CLEAR DTCS ).
Is DTC 53-FF indicated?
YES -Replace the original SRS unit (see SRS UNIT REPLACEMENT ).
NO -Update is complete.