SRS Unit Replacement: Installation

Install the SRS unit (A) with new TORX bolts (B), then connect the SRS unit connectors (C) to the SRS unit; push them into position until they click and the lever locks are fully secured (see LEVER-LOCKED CONNECTOR ).
NOTE: Be sure the SRS unit is sitting squarely against its bracket before torquing the TORX bolts.

Fig 1: SRS Unit, Torx Bolts And SRS Unit Connectors With Torque Specifications
Courtesy of AMERICAN HONDA MOTOR CO., INC.
Do the 12 volt battery terminal reconnection procedure (see RECONNECTION ).
Make sure the SRS unit has the latest software. If it does not have the latest, update the software in the SRS unit (see SRS UNIT UPDATE ).
Do the front passenger's weight sensor initialization (see FRONT PASSENGER'S WEIGHT SENSOR INITIALIZATION ).
Do the ODS unit operation check (see ODS UNIT OPERATION CHECK ).
Confirm proper SRS operation: Turn the ignition switch to ON (II), and check that the SRS indicator comes on for about 6 seconds and then goes off.
Reinstall all removed parts.