LEMON Manuals: Even more car manuals for everyone: 1960-2025
Home >> Honda >> 2012 >> Odyssey EX >> Repair and Diagnosis >> Accessories & Equipment >> Entertainment Systems >> Navigation System >> Navigation Display Visor Removal/Installation
April 5, 2026: LEMON Manuals is launched! Read the announcement.

Navigation Display Visor Removal/Installation

NOTE:
  • Do this procedure in a clean place free from dirt.
  • Wear latex or vinyl gloves when doing this procedure (Do not use fabric gloves).
  • When removing the navigation display visor, do not touch the LCD facing.
  • If there is dirt on the LCD facing, clean it using compressed air.
  • When installing the navigation display visor onto the LCD assembly, be careful not to touch the LCD facing.
  • Check that the navigation display visor and the LCD assembly are properly installed.
  • Since the LCD assembly and the navigation display visor are installed at an angle, be sure that the screws are properly seated. If not properly seated, tighten the screws.
  • Check that the navigation display unit assembly has no damage.
  • When removing the navigation display visor, do not hold the LCD facing down.
  1. Remove the navigation display unit (see NAVIGATION DISPLAY UNIT REMOVAL/INSTALLATION  ).
  2. Remove the screws and the LCD assembly (A) from the navigation display visor (B).
    Fig 1: Locating LCD Assembly And Navigation Display Visor
    G06971237Courtesy of AMERICAN HONDA MOTOR CO., INC.
  3. Install the navigation display visor reverse order of removal.
scientia non olet · About LEMON Manuals