Switch Test/Replacement

NOTE: SRS Components are located in this area. Review the SRS component locations (see COMPONENT LOCATION INDEX ), and precautions and procedures (see PRECAUTIONS AND PROCEDURES ) before doing repairs or servicing.

Remove the driver's recline cover (see FRONT SEAT RECLINE COVER REMOVAL/INSTALLATION ).
Disconnect the 5P connector from the lumber support switch (A), then separate the cover (B).

Fig 1: Identifying 5P Connector, Lumber Support Switch, And Cover
Courtesy of AMERICAN HONDA MOTOR CO., INC.
Check for continuity between the terminals in each switch position according to the table.

Fig 2: Identifying Switch Terminal Continuity Chart
Courtesy of AMERICAN HONDA MOTOR CO., INC.
If the continuity is not as specified, replace the switch.
Install the switch in the reverse order of removal