Audio Remote Switch Test/Replacement

SRS components are located in this area. Review the SRS component locations (see COMPONENT LOCATION INDEX ) and the precautions and procedures (see PRECAUTIONS AND PROCEDURES ) in the SRS section before doing repairs or service.

1. Remove the driver's airbag assembly (see DRIVER'S AIRBAG REPLACEMENT ).
2. Remove the steering wheel (see STEERING WHEEL REMOVAL ).
3. Remove the audio remote switch (see STEERING WHEEL DISASSEMBLY/REASSEMBLY ).
Fig 1: Identifying Audio Remote Switch Connector Terminals
Courtesy of AMERICAN HONDA MOTOR CO., INC.
4. Measure the resistance between terminals No. 4 and No. 12 in each switch position according to the table.
   RESISTANCE REFERENCE
   
   

   Position	Resistance
   No button pressed	About 10 kΩ
   MODE	About 3.7 kΩ
   CH(+)	About 1.7 kΩ
   CH(-)	About 775 Ω
   Δ (VOL. UP)	About 357 Ω
   ↓ (VOL. DOWN)	About 100 Ω

5. If the resistance is not as specified, replace the audio remote switch.
6. Use a diode tester between the terminals in each switch position according to the table.
   Fig 2: Terminal Chart

   Courtesy of AMERICAN HONDA MOTOR CO., INC.
7. If the diode test is bad, replace the switch.
8. Install the audio remote switch in the reverse order of removal.